Home > RIP Questions

RIP Questions

July 29th, 2017 in ROUTE 300-101 Go to comments

Question 1

Question 2

Question 3

Question 4

Explanation

RIP can only be turned on under router sub command (in Router(config-router)# mode). Unlike OSPF or EIGRP, RIP cannot be enabled from interface sub command (Router(config-if)# mode)

Comments
  1. Kili
    August 15th, 2017

    Question 4

    I think answer C is incorrect. To enable RIP we should be in global configuration mode .

    Enabling RIP

    To enable RIP, use the following commands beginning in global configuration mode:

    abc> enable //User EXEC Mode > Privileged EXEC Mode
    abc# configure terminal //Privileged EXEC Mode > Global Configuration Mode
    abc(config)#router rip //Enables a RIP routing process, which places you in router
    configuration mode. After RIP is enabled :
    abc(config-router)# network {network IP address} // Associates a network with a RIP
    routing process
    In my oppinion answer B is the correct .
    We have a question to enable RIP , not to configure it.

    https://www.cisco.com/c/en/us/td/docs/ios/12_2/configfun/configuration/guide/ffun_c/fcf019.html

    https://www.cisco.com/c/en/us/td/docs/ios/12_2/ip/configuration/guide/fipr_c/1cfrip.html#wp1000952

  2. Kili
    August 16th, 2017

    RIP Questions
    Question 4

    I think answer C is incorrect. To enable RIP we should be in global configuration mode .

    Enabling RIP

    To enable RIP, use the following commands beginning in global configuration mode:

    abc> enable //User EXEC Mode > Privileged EXEC Mode

    To enter global configuration mode, use the
    configure terminal in privileged EXEC command

    abc# configure terminal //Privileged EXEC Mode > Global Configuration Mode
    abc(config)#router rip //Enables a RIP routing process, which places you in router
    configuration mode. After RIP is enabled :
    abc(config-router)# network {network IP address} // Associates a network with a RIP
    routing process
    In my oppinion answer B is the correct one.
    We have a question to enable RIP , not to configure it.

  3. anu
    August 18th, 2017

    Engineer has to enable RIP on a link. Where he will issue the command?
    A. IPv6
    B. Global
    C. Router sub command
    D. Interface sub command

    what is the correct answer for this?

  4. Anonymous
    August 21st, 2017
  5. Urumiko
    August 29th, 2017

    @Kili

    If the question was to just “enable rip” this would be global.
    but if it is specifying “on an interface” then C is correct.
    It is testing whether you know that rip cannot be enabled under interface configuration, and is instead enabled by the “network” command under router config mode.

  1. No trackbacks yet.